February 12th, 2012 by Dwayne
Yep, that’s right; a way to keep your misting system working when the power goes out. Of course, this only applies to the DIG 5006-IP misting system timer because it needs electricity to control the misting solenoid valves. For a limited time, the report is completely free at mistkits but will soon be a paid [...]
Read the rest »
January 22nd, 2012 by Dwayne
Yes, THAT Monrovia! One of the largest suppliers of plants to nurseries across the country chose a DIG 5006-IP misting timer. How do I know this? Simple, I sold it to them! I was quite shocked when the order was placed to find Monrovia Nursery one of my customers; pleasantly shocked though. So if the [...]
Read the rest »
January 22nd, 2012 by Dwayne
How to get an estimate of how many misting nozzles per zone you can use. To get a good understanding of how many mist nozzles you can use per zone with your mist system, you have to do a little groundwork first. This is not a 100% accurate method, but will work for you to [...]
Read the rest »
July 28th, 2011 by Dwayne
Have you programmed your DIG misting timer and it just won’t start for you? Well, here is a video I did that shows the most common reason.
Read the rest »
May 28th, 2011 by Dwayne
Although the DIG 510 series of misting timers have been discontinued, here is a video to help you program one if this is the timer you own. Although the timer in the video is a DIG 710 series, the programming is exactly the same. The one difference is the 710 uses one 9 volt battery [...]
Read the rest »
April 26th, 2011 by Dwayne
Need help programming your DIG 710 battery operated misting timer? Check out this video.
Read the rest »
January 26th, 2011 by Dwayne
Instead of writing a lengthy article about how to program a DIG 5006-IP electric misting timer, I am just going to give you a video. I find videos are great for folks to follow because they can pause and rewind if needed. Enjoy!
Read the rest »
December 31st, 2010 by Dwayne
Are you currently building a misting system and are not sure how to install your misting nozzles into the overhead piping? Here is a short video I put together that should clear things up a bit. Please note that I use only Dramm nozzles, but installing different ones would be relatively the same process. The [...]
Read the rest »
December 31st, 2010 by Dwayne
Do you need to reprogram your DIG 5006-IP misting timer? Maybe you tried to make an adjustment and screwed the program up. Maybe you just want to start from scratch and program the timer to irrigate as well as mist. No matter. This video will walk you through the steps. Be sure to pay special [...]
Read the rest »
December 31st, 2010 by Dwayne
Are you wondering how to wire your DIG 5006-IP misting timer to operate a single zone to mist your cuttings? This video will walk you through the process and explain how to program the timer as well.
Read the rest »